Climatech - insulself

Clim self adhesive hangers (SC) are designed to fix insulating materials to smooth surfaces such as airducts, attenuators, chambers and enclosures. Their use allows a proper quality fixture speedily and without the risk of corrosion. The adhesive foam backing is of the highest quality and the locking Clim fastener clips (CL-2) ensure an outstanding assembly. In order to meet all requirements, Climatech produces a wide range of pins lengths.

Self-adhesive hangers comprise of a galvanised steel nail (copper or aluminium alternatives on request) firmly mounted on a galvanised steel base which is backed by a self-adhesive, closed cell polyethylene foam substrate.

Galvanised spring steel fastening clips (CL-2) (locking washers) are supplied with the hangers. They ensure a perfect upholding of the insulation. These clips ensure the insulation is held securely in place on the pins, acting as a locker washer. Clim nylon safety point covers (NSC-27) can be supplied to cover the ends of the nails for site protection of personnel.

SC Self-adhesive hangers

Galvanised steel with self-adhesive base 50 x 50 mm (2" x 2")
Zinc plated steel pins (copper/aluminium on request) diameter 2.7 mm (12 ga. - .105") and lengths from 19 to 203 mm (3/4" to 8")

Fastening clips CL-2

Galvanised spring steel
Bevelled edges
Standard outside diameter 30 mm (1-3/16")
Optional outside diameter 38 mm (1-1/2")

Protective nylon cap NSC-27

Nylon safety point cover
Strips of 10 pieces

Standard adhesive foam

White closed cell polyethylene foam backing
Acrilyc adhesive coated on both sides
Silicon protective release paper
Service temperature ranging from -40° C to + 80° C (+100° C for short periods of time)
Resistant to water, detergents, alcohols, alifatic solvents and some aromatic solvents
Not for use in application likely to make contact with chlorinated, cetonic or ester solvents
Contact Climatech if in doubt about application or for specific advice